Table of Contents
Advertisement
Installing the power supply:
1. Carefully install the power supply into the
logic unit so that the power supply fan
assembly faces the front of the logic unit.
2. Slide the power supply toward the back of
the logic unit until it stops.
3. Make sure that the power supply is seated
correctly, and firmly into the logic unit.
4. Secure the power supply with the three
Phillips head screws A removed during the
power supply removal procedure.
5. Slide the support plate B into place between
the riser card and power supply.
6. Secure the support plate with the two Phillips
head screws C removed during the power
supply removal procedure.
7. Install the power connector D into its socket
on the logic board.
8. See "Reassembling the Network Station" on
page 18.
Chapter 4. Performing hardware procedures
23
Advertisement
Table of Contents
