IBM 8364 E series User Manual page 31

Installing an optional CompactFlash card
Read "Caution notices" on page viii, "Removing the
logic unit to install parts" on page 18 and
"Compatible CompactFlash cards" on page ix before
continuing.
1. Match the grooves on the sides of the
CompactFlash card A to the inside of the
connector B .
2. Install the CompactFlash card A into the
connector B .
Note: Do not force the card into the connector, as
it will damage both the Network Station, and the
CompactFlash card.
3. See "Reassembling the Network Station" on
page 18.
Installing an optional PCI card
Complete the procedure, "Removing the logic unit to
install parts" on page 18 before performing the
following Peripheral Component Interconnect (PCI)
procedure.
1. Loosen the thumb screw C to slide the plate E
up.
2. Remove the PCI slot covers F .
3. From inside the logic unit, install the PCI card
down into both the slot, and the PCI socket G .
Note: Inserting the first PCI card into the socket
closest to the logic board makes installing a
second PCI card easier.
4. Install PCI slot covers over any empty slots.
5. Slide the plate E down until the tabs D secure
the PCI slot covers F firmly into place.
6. Tighten the thumb screw C ,
7. See "Reassembling the Network Station" on
page 18.
Chapter 4. Performing hardware procedures
19