IBM 8364 E series User Manual page 33

Selecting the voltage for your location:
Note: All Network Stations are preset to the 230V
setting when manufactured.
1. Power off the Network Station.
2. Remove the base from the Network Station.
3. Locate the voltage selector switch A .
4. Use a pen, or similar object, to slide the switch to
the correct setting for your location (see Voltage
selection in "Detachable power cables" on
page 14).
5. Slide the base back on to the Network Station.
6. Power on the Network Station.
Chapter 4. Performing hardware procedures
21