Départ. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
9.2.7
Assembling the antenna cab
Fit the antenna cab from the top making sure that the top catch on the chassis catches onto the top of the antenna
cab, then press the antenna cab firmly until the three bottom catches snaps onto the rear chassis.
9.8
Replacing the Batter Cover
Insert the battery cell into the bottom of the battery cover. There are two tabs on the inside of the battery
cover, which should be concealed under the battery cell. Then, press the battery cell against the battery cover so
that all the top and side catches locks tightly.
If changing to a new battery cell, please ensure to paste on a new battery label or if replacing the battery cover,
please paste on a new rubber friction pad.
PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
Service Repair Support
2
COMPANY RESTRICTED
VY-V-640-82x
Page : 65 of 71
Langue : EN
Date : 25/02/03
1
VY-V-640-82x