Table of Contents
Advertisement
Départ. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
9.1.6
Remove the keypad assembly
The keypad can be easily removed by lifting. Note that the keypad contact is via the zebra contact on the keypad
holder and the copper pads at the back of the keypad, there is no connection via connectors.
Take care to not apply your fingers on the copper areas and on the zebra contacts.
9.1.7
Separate the Sub Module form the Chassis Ass'y
The sub module is kept in place by the interlock on both sides of the LCD module.
From the rear of the chassis, insert the guitar pit between the LCD's metal clip and the chassis, lightly push inwards
to unlatch the clip.
Repeat for the opposite side.
PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
Service Repair Support
From the front, remove the sub module from the chassis.
COMPANY RESTRICTED
VY-V-640-82x
Page : 57 of 71
Langue : EN
Date : 25/02/03
VY-V-640-82x
Advertisement
Table of Contents
