Départ. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
b) Check Current_ON
- Turn the mobile on.
When the mobile is ON (backlight activated)
For Fisio 820 :
the current measured must be : 150 < I (mA) < 190
For Fisio 825 :
the current measured must be : 200 < I (mA) < 240
This measurement has to be operated during first seconds after switch on.
When the backlight goes down
models
c) Check Current_maximum
- Press on OK to activate Page selection. Press the Key 1 and then OK to select Page 1
- Press on Key 7 to select Antenna test. Press on the Key 8 as much times as necessary to reach level 5.
mobile is now set at his maximum emission level)
When the mobile is emitting (backlight OFF) the current measured must be :
- Remove the battery.
- Gently slide the card out away from the Product
PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
Service Repair Support
, the current measured must be : 15 < I (mA) < 19
(after 15 sec approx.)
COMPANY RESTRICTED
VY-V-640-82x
Page : 42 of 71
Langue : EN
Date : 25/02/03
195 < I (mA) < 350
VY-V-640-82x
for both
(The