Nortel Contivity 1010 Manual page 36

36 Chapter 2 Getting started
If you use Point to Point Protocol over Ethernet (PPPoE), you must use the
Web-based management utility for advanced configuration options to enable
it:
a
b Click on Manage Switch and enter admin and setup as the username and
c
d For Administrative State, click on Enable.
e
f
g Go to an external Web site to verify Internet access.
Alternatively, you can use the following CLI commands to configure PPPoE
client (with username – abc and password xyz):
interface fastethernet 1/1
ip address type static # is it needed
pppoe ppp username abc password xyz
pppoe enable
exit
If you use static IP addressing, you must use the Web-based management
utility for advanced configuration options to enable it:
a
b Click on Manage Switch and enter admin and setup as the username and
c
d Select IP from the Select Protocol list.
e
f
g Click on OK.
h Go to an external Web site to verify Internet access.
315535-A Rev 00
Open the Web browser and enter http://192.168.1.2.
password.
Go to the System→LAN screen, select PPPoE from the Select Protocol
list and click on Apply. The Add PPPoE Interface screen appears.
For Interface Filter, select permit all.
Click on OK.
Open the Web browser and type http://192.168.1.2.
password.
Go to the System→LAN screen. s
Click on Apply. The Add IP Address screen appears.
Select the Static option and type the IP address and the subnet mask.