Configuring Pppoe - Nortel Contivity 1010 Manual

a
b Enter the host name that is registered with DNS.
c
d Enter the Ethernet (MAC) address.
e
10 The server does not implement configuration changes until it is restarted.
Return to the Server→DHCP screen and select the Restart Server option to
restart the DHCP server.
11 To verify the configuration changes, go to the Status→Health Check screen or
click on the DHCP Stats button on the Status→Statistics screen.

Configuring PPPoE

Point-to-Point Protocol over Ethernet allows PPP to run over Ethernet. It is used
by DSL or cable modem users for access to the Internet. PPPoE has the following
usage restrictions:
• Cannot use dynamic routing on PPPoE interfaces
• PPPoE can only be supported on one interface at a time
• Must be set on a public Ethernet interface
• Must set the Administrative State to enabled (disabled by default)
• Must set the appropriate filter (deny all by default)
• PPPoE changes are dynamically applied
Figure 8 shows the System→LAN screen.
Click on the Add button. The Host screen appears.
Enter the IP address that you always want to reserve.
Click on OK.
Chapter 2 Getting started 25
New Features for the Contivity 1010/1050/1100