The Setup Menu - Teac GX-1 Instruction Manual

Explanations of Menus
S o r t
When the Waveform Display window is displayed and the displayed channel is
changed by the Channel Select Palette, the order of graphs in the windows might get
out of order. In such a case, the Sort command orders the graphs in the order of the
channels. Select Ascending to sort so that the lowest channel numbers are at the
top. Select Descending to sort so that the highest channel numbers are at the top.
System
Modifies the settings for recording activity.
1
2
3
4
5
8
1. Voice Memo
From Voice Memo, select MIX, BEFORE, or AFTER, to record voice memo.
Details of each mode are explained on the next page.
2. IRIG
When IRIG displays ON, at the start of recording the GX-1 internal clock is cor-
rected by an IRIG-B time code input through the DIGITAL CONTROL connec-
tor. Be sure to supply the IRIG-B time code signal when selecting ON. If not
supplied, the unit will not enter Rec Standby status.
3. Count
In Count, select the units for k (kilo) of the sampling frequency: either 1,000 or
1,024.
3-26

The Setup Menu

Select ON/OFF to control
recording solely with the
remote controller ER-
GXRC (without a PC).
Saving the settings
6
The settings in the Setup menu are stored in
7
the memory of the GX-1 main unit. These set-
tings are read to a PC when the GX Navi starts.
9
When you select 1,024 for Count, the sampling
frequencies that do not make up a full k are
converted as follows: 500 to 512, 200 to 204.8,
100 to 102.4, and so on. However, note that the
display in the PARAMS menu will not change.
Also note that the value [sampling-frequency x
number-of-channels x 1.024] cannot exceed
3,200 kHz.
The Count must be 1k = 1000 at 200 kHz sam-
pling.