About Ait Cartridge - Teac GX-1 Instruction Manual

Installation

About AIT Cartridge

Inserting an AIT Cartridge
To insert an AIT cartridge:
1.
Turn on the power to the GX-1 main unit.
The buzzer will sound three pairs of beeps.
2.
Open the door to the AIT drive.
3.
Insert the AIT cartridge.
After the AIT cartridge is inserted part of the way, it will be
set automatically.
4.
Close the door to the AIT drive.
Wait until the activity display on the status toolbar shows
"READY".
Removing the AIT Cartridge
Eject AIT Before Power-off
Remove the AIT cartridge before turning off the
power to the GX-1. The volume information will be
written just before the cartridge is ejected. If you turn
off the power while the AIT is still inserted, the data
recorded on that AIT cartridge might become unread-
able.
To remove an AIT cartridge:
1.
Open the door of the AIT drive.
2.
Click the Eject button (
software, or use the LCD controller to perform the Eject
operation.
The AIT cartridge will be ejected.
3.
Take the AIT cartridge out of the GX-1.
4.
Close the door on the AIT drive.
Notes:
You cannot remove an AIT cartridge during recording or
reading of data. Pressing the EJECT button will have no
effect.
Quitting GX Navi automatically ejects the cartridge.
2-8
) on the toolbar in the attached
Pressing the EJECT button on the AIT drive will have no
effect while software is running or while the LCD controller
is performing an operation.
EJECT button