Xerox DocuColor 2240 Service Manual page 1483

Fax Kit Installation
Purpose
The purpose of this kit is install a Fax Module on WorkCentre 24 machines.
Kit Contents
Check the kit contents against the following list:
Fax I/F PWB
Fax Module Screw, M3x6 (8)
Self-tapping
Bracket (R)
Screw, M3x6
Figure 1 Kit Contents
Procedure
Installing the Riser Chassis
1. Switch off the copier and disconnect both power cords.
2. Disconnect the Scanner Cable from the Rear Panel on the machine.
3. If applicable remove the Finisher from the machine
Gate Assembly (PL 17.2).
4. Remove the Rear Cover (REP 14.2).
5. Remove the Right Cover (REP
6. Remove the Top Cover (REP 14.1).
Protect the Hard Drive Harness when removing the ESS Top Cover. The Hard Drive is
mounted to the cover. The harness remains connected to the ESS PWB while removing the
cover.
7. Remove the DIMM Cover and the ESS Top Cover
8. Remove the 4 screws shown in
Installation
Fax Kit Installation
Guide Bracket
Riser Chassis
Wire Harness
Label
One-
Interface Cable Phone Cable (2)
Touch Panel
(REP 12.4), including the Finisher
14.3).
CAUTION
(PL 13.1).
Figure 2.
Plate
Remove screws
(4).
Bracket (L)
9. Install the Riser Chassis
2
Align the Riser connector
and ESS connector and
press firmly
10. Install the Guide Bracket and Plate
09/03
9-8
Rear of machine
Figure 2 Preparing to Install Riser
(Figure 3).
Figure 3 Installing Riser
(Figure 4).
DC 3535/2240/1632, WC M24
3
Reinstall the screws
removed in step 8
1
Align the holes in the
Riser with the holes
in the ESS PWB.
Initial issue