IBM pSeries 690 Service Manual page 288

Hide thumbs Also See for pSeries 690:

Table of Contents

Step 152i-22

Have all the cards listed in "Step 152i-15" on page 271 been reinserted?

The symptom has changed. This ends the procedure.

Return the system to its original configuration.

Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information

for Multiple Bus Systems.

Go to "Step 152i-19" on page 271.

Step 152i-23

Turn off the power.

Examine all the green "power good out" LEDs of both I/O subsystem DCAs.

Step 152i-24

Are all the green "power good out" LEDs of both I/O subsystem DCAs off?

Go to "Step 152i-25."

Call for support.

Step 152i-25

Remove the following adapter cards, if present, from the I/O subsystem. record the adapter locations:

v Adapter card at P2-I1

v Adapter card at P2-I2

v Adapter card at P2-I3

v Adapter card at P2-I4

v Adapter card at P2-I5

Step 152i-26

Turn on the power.

Step 152i-27

Did the system stop with the same error code as recorded in "Step 152i-1" on page 269?

Go to "Step 152i-33" on page 273.

Go to "Step 152i-28" on page 273.

Eserver pSeries 690 Service Guide