IBM pSeries 690 Service Manual page 305

Hide thumbs Also See for pSeries 690:

Table of Contents

Step 152k-22

Have all the cards listed in "Step 152k-15" on page 288 been reinserted?

The symptom has changed. This ends the procedure.

Return the system to its original configuration.

Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information

for Multiple Bus Systems.

Go to "Step 152k-19" on page 288.

Step 152k-23

Turn off the power.

Examine the green "power good out" LEDs of both I/O subsystem DCAs.

Step 152k-24

Are all the green "power good out" LEDs of both I/O subsystem DCAs off?

Go to "Step 152k-25."

Call for support.

Step 152k-25

Remove the following adapter cards, if present, from the I/O subsystem. Record the adapter locations:

v Adapter card at P2-I1

v Adapter card at P2-I2

v Adapter card at P2-I3

v Adapter card at P2-I4

v Adapter card at P2-I5

Step 152k-26

Turn on the power.

Step 152k-27

Did the system stop with the same error code as recorded in "Step 152k-1" on page 286?

Go to "Step 152k-33" on page 290.

Go to "Step 152k-28."

Step 152k-28

One of the cards just removed is defective.

Turn off the power.

Make sure all the green "power good out" LEDs of both I/O subsystem DCAs are off.

Step 152k-29

Reinsert one of the cards that is removed and listed in "Step 152k-25."

Step 152k-30

Turn on the power.

Chapter 3. Maintenance Analysis Procedures