IBM pSeries 690 Service Manual page 216

Hide thumbs Also See for pSeries 690:

Table of Contents

Is the error code that sent you to this MAP still reported?

The problem has been corrected. Go to "MAP 0410: Repair Checkout" in the RS/6000 and

Eserver pSeries Diagnostic Information for Multiple Bus Systems.

Call for support. This ends the procedure.

Note: Read the Danger and Caution notices under "Safety Notices" on page vii before continuing with this

Prepare a multimeter to measure up to 600 V ac.

2. Use the multimeter to measure the ac voltage at the test points on the frame labeled Phase A and

Is the ac voltage greater than 180 V ac?

Inform the customer that the line voltage into the BPA is missing or too low. This ends the

Independent faults are indicated on both sides of the BPA. Each side must be isolated separately.

Call for support. This ends the procedure.

Eserver pSeries 690 Service Guide