Jenn-Air SEG196 Use And Care Manual page 9

Your new cooktop burnershave been preset for an "average" set of conditions. Re-
gional variances in gas pressure and atmosphericconditions such as height above
sea level may affect your initialflame performance,
When the control knob is turned ON, gas enters the mixer tube and mixes with air,
This air end gas mixture flows to the burner head and is lighted by a spark from the
solid state igniter.
A propedy adjusted burner with clean pods will light within a few seconds. The cone-
shaped flame w_llbe clear blue in colorwith a ¢leady defined innercone. There should
be no trace of yellow in the flame. A yellow flame indicates an improper mixture of air
and gas. If your flame does not resemble the "correct" flame as described above,
follow the air shutter adjustment instructions below.
The (nfinite surface controls provide flexibility in heat setting selection.
Note: The grill can be replaced with an optional surface burner module, Model AG202.
Surface Burners
In case of prolongedpowerfailure, you can manually light the surface burnerby
holding a lighted match near the burner ports and slowly turning the control knob
counterclockwise (after depressing) until the gas ignites. There is no fan so smoke
and condensation can gather.
Grill
IN CASE OF POWER FAILURE, DO NOT USE GRILL, VENTILATION SYSTEM WILL
NOT OPERATE,
IF THE VENTILATION SYSTEM IS INOPERABLE FOR ANY REASON, DO NOT
OPERATE GRILL.
9