Jenn-Air SEG196 Use And Care Manual page 47

Gas-electric grill-range

Hide thumbs Also See for SEG196:

Before replacing bulb, disconnect power to oven at the main fuse or circuit braaker panel

and at the electric receptacle. Be sure that the entire oven cavity including the light bulb

is cool before attempting to remove.

To replace light bulb:

1. Carefully removethe grasslightlens and lens retainerby

removingthe two screwsin the lightlens retainer usinga

phillipsscrewdriver. Note: The lightlens is separatefrom

the lightlens retainer. The two pieceswilldrop downinto

your hands at the same time.

Do NOT remove the

remaining two screws.

2. To obtain firm grasp on bulb, wear protective rubber

gloves. Remove by turning bulb to the left. Do not touch

a hot oven lightbulb witha damp clothas bulbwill break,

Note: If thebulbdoes break and you wishto removeit, be

certainpowersupplyis disconnectedand wear protective

I \\

gloves.You may contactyourauthorizedJenn-AirService

Contractorfor service.

3. Replace bulb with a 40 watt oven-rated appliance bulb.

Bulbwith brassbaseis recommended to preventfusingof

bulbinto socket.

4. Place light lens inside of light lens retainer. Holdingthe

lightlens and lens retainerin place, insertthe two screws

intothe lightlens retainerand tighten.

Jenn-Air'sventilationsystemisdesignedto capturebothcookingfumes and smokefrom

anyplaceonthe gdll surface. Ifthe systemdoesnot,theseare somedustinginstallation

situationsto check:

• 6" diameterroundor 3¼" x 10" rectangularductingshouldbe usedfor ductlengths

10'-60'. 5" diameterround ductingmustbe used if the duct lengthis 10' or less.

• No morethan three 90° elbows shouldbe used. Distancebetween elbowsshould

be at least 18".

• Recommended Jenn-Air wall cap should be used, Make sure damper movesfreely

when ventilation system is operating.

• There should be a minimum clearance of 6" for cooktop installed near a side wall.

If there is not an obvious improper installation, there may be a concealed problem such

as a pinched joint, obstruction in the pipe, etc. Installation is the responsibilityof the

installer and questions should be addressed first by the installer. The installer should

very carefully check the ducting installation instructions.