Jenn-Air SEG196 Use And Care Manual page 13

• Since the controlsare a push-turntype, they mustbe pusheddownbefore turning.
To set (fromthe OFF position),push downon controlknob and immediately turn
counterclockwise to the LITE positionuntilburnerignites. After ignition, t urnknob
clockwiseto desired setting.
• Igniterwillcontinue to sparkuntilknobisturnedclockwisebacktoor pastHI position
on knob.
I INLt
", \ / I
1. 2. 3. 4.
Control Locations
Note: When using an AG200 surface
1. Left rear surface burneror grill burnerassemblywith controllocations#1
2. Left frontsurface burneror grill and #2, the controlknobmay be turnedto
3. Right rear surface burner a positionlowerthan the Lo setting.(The
4. Right frontsurface burner Lo settingis set for the grill burner.)
The size and type of cookwareand the amount and type of food being cooked will
influence the setting neededfor best results. The setting indicatedshouldserve as a
guide whileyou becomefamiliar withyour cooktop.
Use theHi flamesettingtoquicklybringfoodsto a boil _,_
or to begin a cookingoperation. Then reduceto a _
lower settingto continuecooking. Never leave food _.._._.__
unattended over a Hi flame setting.
Med setting is usedto continuea cookingoperation.
Food will not cook any faster when a higherflame
settingis usedthan that neededto maintaina gentle
boil. Remember,water boilsat the same tempera-
ture whetherboilinggentlyor vigorously.
©
Use Lo settingto keepfoodat servingtemperatures _
without further cooking. You may find that some
cookingmay take place if the cookwareis covered.
14