Configuring And Using Interface Range Macros - Cisco Catalyst 3560-X Software Configuration Manual

Using Interface Configuration Mode

Configuring and Using Interface Range Macros

You can create an interface range macro to automatically select a range of interfaces for configuration.
Before you can use the macro keyword in the interface range macro global configuration command
string, you must use the define interface-range global configuration command to define the macro.
To define an interface range macro, follow these steps beginning in privileged EXEC mode:
Command
Step 1 configure terminal
Step 2 define interface-range macro_name
interface-range
Step 3 interface range macro macro_name
Step 4
end
Step 5 show running-config | include define
Step 6 copy running-config startup-config
Use the no define interface-range macro_name global configuration command to delete a macro.
When using the define interface-range global configuration command, note these guidelines:
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-24
Valid entries for interface-range:
– vlan vlan-ID - vlan-ID, where the VLAN ID is 1 to 4094
– gigabitethernet module/{first port} - {last port} (for 3560-X switches), where the module is
always 0
– gigabitethernet stack member/module/{first port} - {last port} (for 3750-X switches), where
the module is always 0
tengigabitethernet module/{first port} - {last port} (for 3560-X switches), where the module
–
is always 0
tengigabitethernet stack member/module/{first port} - {last port} (for 3750-X switches),
where the module is always 0
gigabitethernet stack member/module/{first port} - {last port}, where the module is always 0
tengigabitethernet stack member/module/{first port} - {last port}, where the module is
–
always 0
port-channel port-channel-number - port-channel-number, where the port-channel-number
–
is 1 to 48.
When you use the interface ranges with port channels, the first and last port-channel
Note
number must be active port channels.
Purpose
Enters global configuration mode.
Defines the interface-range macro, and saves it in NVRAM.
The macro_name is a 32-character maximum character string.
•
A macro can contain up to five comma-separated interface ranges.
•
• Each interface-range must consist of the same port type.
Selects the interface range to be configured using the values saved in
the interface-range macro called macro_name.
You can now use the normal configuration commands to apply the
configuration to all interfaces in the defined macro.
Returns to privileged EXEC mode.
Shows the defined interface range macro configuration.
(Optional) Saves your entries in the configuration file.
Chapter 1 Configuring Interface Characteristics
OL-25303-03