Cisco Catalyst 3560-X Software Configuration Manual page 161

Chapter 1 Managing Switch Stacks
Command
Step 6
rsu {active | standby}
Step 7 end
Step 8 archive download-sw
/rolling-stack-upgrade
Step 9 show switch stack-upgrade sequence
Step 10
show switch stack-upgrade status
Step 11
show running-config
Step 12 copy running-config startup-config
Step 13 archive download-sw /force-reload
To run the rolling stack upgrade:
Switch# configure terminal
Switch(config)# boot time 15
Switch(config)# interface gigabitethernet 1/0/1
Switch(config-if)# rsu active
Switch(config-if)# exit
Switch(config)# interface gigabitethernet 4/0/1
Switch(config-if)# rsu standby
Switch(config-if)# end
Switch# archive download-sw /rolling-stack-upgrade
Switch# show switch stack-upgrade status
Upgrade Time Remaining: 21 minutes
Unupgraded Stack:
Switch#
1
2
3
Upgraded Stack:
Switch#
Switch#
...
Switch# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
.....
Switch# archive download-sw /force-reload
...
OL-25303-03
Purpose
On another member, configures the other half of the redundant uplink,
and assigns the other role to the member interface.
• active—Sets the interface to active.
• standby—Sets the interface to standby.
Note If spanning tree protocol (STP) is enabled, set the standby role
to the blocked interface.
By default, the role is not set.
To configure another pair, repeat Step 3 to Step 6.
Returns to privileged EXEC mode.
Starts the rolling state upgrade process to upgrade the members one at a
time.
(Optional) During the upgrade process, displays the member upgrade
sequence.
(Optional) During the upgrade process, displays the rolling stack
upgrade status.
(Optional) Verifies the software image running on the member.
Saves the stack configuration in the configuration file.
(Optional) Forces a system reload after the rolling stack upgrade.
Enter this command only if you want the stack to keep the original
master and not elect a new one.
Status
RSU in Progress
RSU in Progress
RSU in Progress
Status
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring the Switch Stack
1-29