Configuring Span And Rspan; Default Span And Rspan Configuration; Configuring Local Span - Cisco Catalyst 3560-X Software Configuration Manual

Configuring SPAN and RSPAN

Configuring SPAN and RSPAN
•
•
•

Default SPAN and RSPAN Configuration

Table 1-1
Feature
SPAN state (SPAN and RSPAN)
Source port traffic to monitor
Encapsulation type (destination port)
Ingress forwarding (destination port)
VLAN filtering
RSPAN VLANs

Configuring Local SPAN

•
•
•
•
SPAN Configuration Guidelines
•
•
•
•
•
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-12
Default SPAN and RSPAN Configuration, page 1-12
Configuring Local SPAN, page 1-12
Configuring RSPAN, page 1-17
Default SPAN and RSPAN Configuration
SPAN Configuration Guidelines, page 1-12
Creating a Local SPAN Session, page 1-13
Creating a Local SPAN Session and Configuring Incoming Traffic, page 1-15
Specifying VLANs to Filter, page 1-16
On each switch stack, you can configure a maximum of 2 source sessions and 64 RSPAN destination
sessions. A source session is either a local SPAN session or an RSPAN source session.
For SPAN sources, you can monitor traffic for a single port or VLAN or a series or range of ports
or VLANs for each session. You cannot mix source ports and source VLANs within a single SPAN
session.
The destination port cannot be a source port; a source port cannot be a destination port.
You cannot have two SPAN sessions using the same destination port.
When you configure a switch port as a SPAN destination port, it is no longer a normal switch port;
only monitored traffic passes through the SPAN destination port.
Entering SPAN configuration commands does not remove previously configured SPAN parameters.
You must enter the no monitor session {session_number | all | local | remote} global configuration
command to delete configured SPAN parameters.
Chapter 1
Default Setting
Disabled.
Both received and sent traffic (both).
Native form (untagged packets).
Disabled
On a trunk interface used as a source port, all VLANs are
monitored.
None configured.
Configuring SPAN and RSPAN
OL-25303-03