Scheduling A Reload Of The Software Image - Cisco Catalyst 3560-X Software Configuration Manual

Hide thumbs Also See for Catalyst 3560-X:
Table of Contents

Advertisement

Chapter 1
Assigning the Switch IP Address and Default Gateway
Table 1-4
Environment Variables (continued)
Variable
SWITCH_NUMBER
SWITCH_PRIORITY set SWITCH_PRIORITY
When the switch is connected to a PC through the Ethernet management port, you can download or
upload a configuration file to the boot loader by using TFTP. Make sure the environment variables in
Table 1-5
Table 1-5
Variable
MAC_ADDR
IP_ADDR
DEFAULT_ROUTER

Scheduling a Reload of the Software Image

You can schedule a reload of the software image to occur on the switch at a later time (for example, late
at night or during the weekend when the switch is used less), or you can synchronize a reload
network-wide (for example, to perform a software upgrade on all switches in the network).
A scheduled reload must take place within approximately 24 days.
Note
OL-25303-03
Boot Loader Command
set SWITCH_NUMBER
stack-member-number
Changes the member number of a stack
member.
stack-member-number
Changes the priority value of a stack member.
are configured.
Environment Variables for TFTP
Description
Specifies the MAC address of the switch.
Note
However, if you modify this variable after the boot loader is up or the value
is different than the saved value, enter this command before using TFTP.
Specifies the IP address and the subnet mask for the associated IP subnet of
the switch.
Specifies the IP address and subnet mask of the default gateway.
Cisco IOS Global Configuration Command
switch current-stack-member-number renumber
new-stack-member-number
Changes the member number of a stack member.
Note
switch stack-member-number priority
priority-number
Changes the priority value of a stack member.
Note
We recommend that you do not modify this variable.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Scheduling a Reload of the Software Image
This command is supported only on
Catalyst 3750-X switches.
This command is supported only on
Catalyst 3750-X switches.
1-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3750-x

Table of Contents