Installing Panels And Modules; Figure 3: Mw720B - Small Enclosure Details; Figure 4: Pcb Mounting Clip; Figure 5: Mw720B Configuration Examples - Bosch Solution 144 Quick Start Manual

Solution 144 Quick Start Guide
I nst a ll in g Pa n el s a n d M o d u le s
Once the enclosure is secured in place, install the panels
and modules onto the mounting clip using the supplied
3mm screws. Do not over tighten the screws.
When fitting panels or large modules, you should use 5
mounting clips, one in each corner of the PCB and one
in the middle of the PCB underneath the main terminal
blocks. When mounting small modules, only 4 clips are
required, 1 in each corner.
Both enclosures are supplied with tamper switches,
tamper leads, tamper brackets and a quantity of
mounting clips and screws.
mounting clips and screws may be purchased in bags of 50
clips (10 packs x 5pcs). (P/N: MW890)
The supplied mounting clips are designed to use the
i
3mm machine screws supplied with the enclosure.
Note
The use of self tapping screws will damage the clips.

Figure 3: MW720B - Small Enclosure Details

Figure 4: PCB Mounting Clip

6
If required, additional
The following example shows the MW720B - Small
enclosure configured using 4 small modules.

Figure 5: MW720B Configuration Examples

Bosch Security Systems 10/12 BLCC600R