Application/Configuration Of Static Routes; General; Configuration - Siemens SICAM RTU User Manual

Automation Units and Automation Networks
6.3

Application/Configuration of Static Routes

6.3.1

General

Static routing is based on a fixed definition of the path of data packages between two end sys-
tems. This definition is written down by administrators in a routing table. This kind of routing
serves for security, respectively is used in network configurations, if several default gateways
are used. Because of the big effort for the manual maintaining of the tables the number of
routes is restricted.
· Number of static routes
· Parameter of static routes
− Source IP address
− Destination IP address
− Gateway IP address
− Subnet mask
· Interfaces
6.3.2

Configuration

Activation of the „static routes"
·
Parameter
static routes
Definition of the routing table
·
Parameter
=
routes
Mode of the Ethernet Ports
·
Parameter
address (connected ports in switch mode)
The data packages are sent via the interfaces X0 and X1.
·
Parameter
addresses (independent ports)
The data packages are sent via that interface (X0 or X1) to which the respective source IP
address (Own IP address X0
250
Network settings | IP address | advanced parameters | Enable
= YES
Network settings | IP address | advanced parameters | static
Number of lines x (max. 10)
Network settings | IP address | Mode of ethernet ports
Network settings | IP address | Mode of ethernet ports
or
Own IP address
CP-2016 CP-2019
10
P
P
P
P
X0, X1
X1) is assigned.
SICAM RTUs, SICAM AK 3 User Manual
Edition 07.2016, DC2-028-2.03
10
P
P
P
P
X0, X1
= 1 IP
= 2 IP