Troubleshooting - Paxar 610 User Manual

Troubleshooting

This section helps you correct some problems that may occur.
Problem
Error message appears during
startup.
Does not print.
Does not feed.
Partially printed data.
Printing shadows or smears
Light printing.
Heavy printing.
Voids in printing.
Blank labels print or 750 series
errors.
If you cannot fix a problem, call Technical Support.
46 Troubleshooting
Action
Turn off the printer, wait fifteen seconds and then turn on the
printer. Call Technical Support if the error message
reappears.
Check supply.
Check ribbon.
Send a corrected batch.
Set wide/narrow knobs correctly. Try the narrow setting first,
if the printing is too light, use the wide setting.
Clean the printhead.
Send a corrected batch.
Clean the printhead.
Change supply.
Check ribbon.
Change supply.
Adjust the print contrast.
Check wide/narrow knobs. Try the narrow setting first, if the
printing is too light, use the wide setting.
Check ribbon.
Clean the printhead.
Change supply.
Adjust the print contrast.
Check the wide/narrow knobs. Try the narrow setting first, if
the printing is too light, use the wide setting.
Check ribbon
Clean the printhead.
Change the supply type.
Check ribbon.
Leave printhead unlatched when not in use.
Clean supply sensors.
Users Manual - 610/611/612 Printers