Example Applications - Remote Control And Real-Time Modulation; Controlling The 9030 From The 8050; Equipment Connections And Settings - Zoom 9030 Operation Manual

Remote control and real-time modulation of the 9030
can
be
accomplished by using MIDI equipment such as the 8050
(optional) or other MIDI instruments.
Controlling the 9030 from the 8050
With the 8050 foot controller, you can switch among the
Patches of the 9030 and bypass specific effect modules by
using your foot. You can a h
control effect parameters of
the 9030 in real time by connecting the
FPOl expression ped-
al to the 8050.
Equipment Connections and Settings
1. Connect the 8050 and the 9030.
Connect the REMOTE OUT erminal of the 8050 to the
REMOTE
IN terminal of the 9030 by using the remote cable
(RC05) included with the 8050. The 8050 does not require
an AC adaptor, since power is supplied from the 9030
through the
REMOTE
terminal.
2. Set the 8050
as
shown below.
MIDI send channel: 1
Mode: Standard mode
Control change number of expression pedal 1: No. 7
Control change number of expression pedal: No. 1
Control change number of BYPASS pedal switch: No. 9 1
The above settings are programmed at the factory. You need
not carry out this operation if the settings have not been
changed.
3, Make sure that the MIDI receive channel of the 9030
and the MIDI send channel of the 8050 are the same,
Call up the page for selecting the MIDI channel in the Utility
mode and either set the MIDI channel
to
1 or set OMNI to
ON.
The display below appears when the MIDI channel is set
to 1.
l
UTY 3
-
1 MIDI CH SEL
CH =P 1 OMNI= OFF
The display on the next page appears when the MIDI chan-
nel is set to omni on.
Instrument Amplifier
L I I
OUTPUT
INPUT
-
R
REMOTEIN DC9V
REMOTE
I
OUT