Entering The Edit Mode; Selecting Effect Modules; Changing Parameter Values; Selecting Pages - Zoom 9030 Operation Manual

Display of the Edit Mode
The parameter names are shown in the top line of the display
in the Edit mode, and the values of each parameter are shown
in the bottom line. The FL display shown below is an exam-
ple of the editing display for the REV effect module.
(4) SFX Routing
This routing is selected when the effect module SFX is on.
/
COMP -AMP
-
SFX
-
REV
\
Edit Mode
What
is
the Edit Mode?
A Patch of the 9030 consists of various effect modules. The
edit mode is used to select individual effect modules and set
their parameters.
Entering the Edit Mode
Press either of the EDIT <
/
> keys from the Play mode.
Pressing the EDIT
c key calls up the display for editing the
REV (reverb group) effect module, and pressing the EDIT >
key calls up the display for editing the COMP (compressor
group) effect module.
Selecting Effect Modules
Repeatedly press the EDIT c or EDIT > key of the same
direction after entering the Edit mode, in order to select the
effect module to be edited. (The effect indicator of the effect
module which is to be edited will flash.)
Helpful
Hint:
It may be easy to think of the operation as circulating around
the Play mode through the edit display of each module. See
the circulation chart on page 13 of the Tutorial section.
I
TYP RvT PDI COL MIX
Rv2 2 . 4 60 5 38
EFFECT' TYPE
1
PARAMETER 2
I
PARAMETER 4
PARAMETER 1 PARAMETER 3
Effect type -- This parameter is used to select the effect
type installed in the effect module.
Parameters 1
-
4 -- These are the corresponding parameters
for the selected effect type.
Changing Parameter Values
The DEC V/INC A keys are used for changing the effect
type. The data of parameters 1 - 4 are also changed when the
effect type is changed.
Data Entry Controls 1 - 4 are used to change the values of
parameters 1 - 4. The indication
"
0
" is shown at the left of
the display when the value is changed. This indicates that a
parameter in this Patch has been changed or edited.
1
TYP RvT PDI COL MIX
B ~ v 2
2 . 4 60
5
38
Selecting Pages
The parameters of each effect module are spread over two or
three parameter pages. Pressing the UTILITY/PAGE key
switches between the pages. When the effect module is
selected by the EDIT c
/
> keys, the first page of the module
is shown. Pressing the UTILITY/PAGE key after the mod-
ule is selected displays the next page of the module in the FL
display.