Enocean; Sending A Control Function - TCS IVW2221-015x Product Information

pendently in front of the list entry, the latest switched status can be seen.
Here, the two control function numbers as well as the serial number can
be configured, whereby the device-individual serial number can be creat-
ed, if required.

enocean

This function is realised identically to the IMM1100 to make sure that an
enocean radio interface FBI4200 can be connected. It can be also used
to indicate switching states without influencing these itself. When trigger-
ing the list entry, a control function with configurable serial number is
sent. The control function number can be selected freely (0 to 200 is pos-
sible). Independent from sending the protocols, the receiving of control
protocols with the configured serial number causes the switch-over of
states, which is indicated under b) by symbols in front of the list entry.
Thus, the control function numbers 01 and 03 realise the state OFF and
the numbers 02 and 04 the state ON.

Sending a control function

Triggering the control function can have three different effects:
 A control protocol is sent (no indication in the menu).
 Two different control protocols are send alternately (indication in the menu
with red/green point). The color of the point shows the triggered switching
process, but not the actual state of the device which is to be switched.
 A control protocol is sent and the execution of the switching process is
indicated in the menu by a red/green point.
 Press the menu button. Select the symbol
Send control function
menu with the function key, if the device is
configured accordingly.
 Select the required function with the naviga-
tion buttons UP or DOWN.
 Trigger by pressing the menu button. An
acknowledgement tone sounds. The OSD is
switched off after 5 s (or switches back to
the live image).
20
. Or call up the