Table of Contents
Advertisement
The colors of the
video image are too
bright or the image
in general is too
bright.
Colors video image
are without contrast.
32
The color intensity control
of the video indoor station
is turned on too much
The brightness control is
turned on too much.
The level of the video
signal is too high.
The terminating resistor at
the end of the strand is
not inserted.
The level of the video
signal is not high enough.
The terminating resistors
are not inserted correctly
at the video distributors.
Reduce the color intensity.
Reduce the brightness.
Reduce the level of the video bus
(e.g. rotary control on the camera
board). This only works, if the bus
termination at the video indoor
station or at the active extended
function is inserted correctly (e.g.
FVY).
Please insert the terminating re-
sistor.
The connection line of a surface-
mounted camera was extended
impermissible.
The cable length between two
active video components was
exceeded impermissible.
Video level loss can be regulated
via the rotary control in active
video components (see product
information of the components.)
Please check if the number of
allowable video indoor stations
per line was not exceeded.
Remove the terminating resistors
at the relevant components. Only
the last video component in one
strand needs a terminating resis-
tor.
Advertisement
Table of Contents
