Turbine Hand Tool- Brushroll - Royal SR30020 Owner's Manual

4. GENERAL MAINTENANCE

4.5 TURBINE HAND TOOL- BRUSHROLL

For Turbine Tool Brushroll replacement replacement (Part# 48414088)
please call 1-800-321-1134 or visit www.royalvacuums.com to locate a
dealer nearest you.
When to Replace Brushroll
When the brushroll bristles are worn, the brushroll should
be replaced.
How to Replace Brushroll
Disconnect cleaner from electrical outlet
1. Remove tool from hose and turn it so the bottom faces
up. Press the latches on either side of the tool and remove
bottom plate (A).
2. Unscrew the two Phillips screws (indicated by arrows)
and remove belt guard (B).
3. Remove brushroll including end plates (C) and discard.
Inspect belt to ensure that it is in good condition. If belt is
cracked, gouged or broken, replace it. (See the following
section for instructions)
Insert brushroll through belt and position belt over gear
teeth (D) on brushroll.
With curved end down, slide end plates (C) of brushroll
into slots (E) on tool.
4. Replace belt guard (B), making sure not to pinch brush
bristles in guard.
5. To replace bottom plate, insert four tabs (F) on edge of
bottom plate into slots on front of tool.
Pivot bottom plate down and snap closed.
B
D
C
E
A
B
F
14