Mount Tool Caddy; Remove Tool Caddy - Royal Power Pak Owner's Manual

TO MOUNT TOOL CADDY
Hold the empty tool caddy with
the flat side facing the back of
the POWER PAK.
Note the groove on the caddy
and the clip on the POWER
PAK as shown (A).
Slide the caddy down over the
clip until it locks. The caddy is
now secure.
Place the dusting brush and
upholstery tool (except the
crevice tool) in the round
pockets on top of the caddy
(B). Push on securely.
Slide the crevice tool into the
slots available under these two
tools. It will enter from both the
right and left sides.
TO REMOVE THE TOOL CADDY
Reach underneath the tool
caddy.
Pull the entire caddy up and off
of the cleaner.