Power Nozzle; Suction Control - Royal SR30020 Owner's Manual

3. HOW TO OPERATE

3.5 POWER NOZZLE

Floor Selector Pedal
Push the Floor Selector Pedal (F) to raise
and lower the Nozzle to clean bare floors and
various carpet pile heights. For maximum
cleaning performance, the following carpet
height settings are recommended:
• Low and Medium settings: for low
to medium pile carpets
• High setting: for very deep pile
carpet where easier pushing effort
is desired, while maintaining good
performance.
NOTE: If the cleaner is difficult to push,
change the floor selector push button to the
next highest setting.
NOTE: Brushroll will automtically shut off in
Bare Floor Mode.

3.6 SUCTION CONTROL

NOTE: For cleaning drapes, throw rugs or
other loose items, you may need to reduce
the suction to prevent sucking the item into
the cleaning tool.
The suction control (J) is located on the can-
ister. Push the (-) button to reduce suction
and the (+) button to increase suction.
To reduce suction even further, slide the
suction control valve (K) on the handle
until desired suction is achieved.
3.6
J
Floor Selector Indicator Light
(G) Indicates the carpet height selected by
the Floor Selector Pedal.
Handle Release Pedal
Step on the Handle Release Pedal (H) to
lower hand grip into cleaning position.
NOTE: Brushroll will not run until handle
is released.
Reset Button
This power nozzle is equipped with an
electrical reset button (I). If the brushroll is
jammed, the reset button will automatically
shut off the brushroll motor. If this happens,
unplug the cleaner and clear jam from brush-
roll. Press the reset button, plug in cleaner
and resume use.
3.5
F
G
I
3.6
K
8
H