Switching On/Off - Mercedes-Benz SLC Operator's Manual

You can adjust the contour of the seat backrests
individually to provide optimum support for your
back.
Switching the seat heating on/off

Switching on/off

G
WARNING
Repeatedly switching on the seat heating can
cause the seat cushion and backrest pads to
become very hot. The health of persons with
limited temperature sensitivity or a limited
ability to react to excessively high tempera-
tures may be affected or they may even suffer
burn-like injuries. There is a risk of injury.
Therefore, do not switch the seat heating on
repeatedly.
Driver's and front-passenger seat
The three red indicator lamps in the button indi-
cate the heating level you have selected.
The system automatically switches down from
level 3 to level 2 after approximately eight
minutes.
The system automatically switches down from
level 2 to level 1 after approximately ten
minutes.
The system automatically switches off approx-
imately 20 minutes after it is set to level 1.
Make sure that the SmartKey is in position 1
X
or 2 in the ignition lock.
To switch on: press button : repeatedly
X
until the desired heating level is set.
To switch off: press button : repeatedly
X
until all the indicator lamps go out.
Problems with the seat heating
The seat heating has switched off prematurely
or cannot be switched on. The vehicle's electri-
cal system voltage is too low because too many
electrical consumers are switched on.
Switch off electrical consumers that you do
X
not need, such as the rear window defroster
or interior lighting.
Once the battery is sufficiently charged,
X
switch on the seat heating again.
AIRSCARF
Switching on/off
G
WARNING
When AIRSCARF is switched on, very hot air
can flow from the vents in the head restraints.
This could result in burns in the immediate
vicinity of the air vents. There is a risk of injury.
Reduce the heater output before it becomes
too hot.
The AIRSCARF function warms the head and
neck area of vehicle occupants with warm air.
The warm air flows out of the holes in the head
restraints.
The three red indicator lamps in the button indi-
cate the heating level you have selected.
Make sure that the SmartKey is in position 2
X
in the ignition lock.
To switch on: press button :.
X
Three red indicator lamps in the button light
up. The blower starts up after a preheating
phase of seven seconds.
Seats
85
Z