Nautilus T624 Service Manual page 53

12. Using a 6mm hex wrench, remove the hardware from the Right Up-
right. Slightly remove the Right Upright from the Base Assembly exposing X2
the Input/Output (I./O) Cables. Disconnect the I/O Cables and remove the
Right Upright.
B
Note: do not crimp cables.
E
F
X2
F
E
A
X2
F
E
A
13. Connect the Input/Output (I/O) Cables and Attach the new Right
Upright to Frame Assembly
Note: this step may take two people to safely hold the Right Upright while
the Cables are connected. Do not crimp the Cables. Do not fully tighten
the Hardware until the Console and Handlebar Assembly has been at-
tached.
14. Place the Base Shrouds back onto the Base Assembly.
8
6
53