Nautilus T624 Service Manual page 100

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet
!
and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure
location.
Note: The Nautilus™ T626 is used in the following images. The procedure is the same for the Nautilus™ T624/T684/T686 and Schwinn
models.
1. Unplug the power cord from the machine and wait 5 minutes. Place the
power cord in a secure location.
2. Using a #2 Phillips screwdriver, remove the 8 indicated screws from the
Lower Handlebar Shrouds.
Note: to assist with re-assembly, record that the self-tapping screws are
used in the center of the Lower Handlebar Shroud.
There are only 2 screws to remove the Handlebar Shrouds on the Nauti-
lus T624/T684 and Schwinn 530 machines.
™ ®
3. Using a #2 Phillips screwdriver, remove the 10 indicated screws from
Console Backing. Be sure not to mix the self-tapping screws from the
previous step.
100
530/570
®
X2
C
D
D
C