Nautilus T624 Service Manual page 101

4. Using a #2 Phillips screwdriver, remove the 8 indicated screws from
Upper Handlebar Shrouds.
Note: there are no Upper Handlebar Shrouds on the Nautilus T624/T684
™
and Schwinn 530 machines.
®
X8
C
5. Using a 6mm hex wrench, remove the indicated hardware from the
Uprights.
X4
F
E
B
X4
F
E
6. Slightly pull the right side of the Console upward enough to expose the
B
Input/Output (I/O) Cable from the Right Upright, and disconnect it.
Note: this step may take two people to safely hold the Console and
Handlebar Assembly and disconnect the cables. Do not crimp the Cables.
7. Fully remove the Console and Handlebar Assembly from the Uprights.
101