Mazda 2 2015 Owner's Manual page 97

Before Driving
Doors and Locks
Function
number
The auto door-lock function is
1
disabled.
All the doors and the liftgate/boot lid
lock automatically when the vehicle
2
speed is about 20 km/h (12 mph) or
more.
All the doors and the liftgate/boot lid
lock automatically when the vehicle
speed is about 20 km/h (12 mph) or
3
more. All the doors and theliftgate/
boot lid unlock when the ignition is
switched from ON to Off.
(Automatic transaxle vehicles only)
When the ignition is switched ON
and the shift lever is shifted from park
4
(P) to any other gear position, all the
doors and the liftgate/boot lid lock
automatically.
(Automatic transaxle vehicles only)
When the ignition is switched ON
and the shift lever is shifted from park
(P) to any other gear position, all the
doors and the liftgate/boot lid lock
5
automatically.
When the shift lever is shifted to park
(P) while the ignition is switched ON,
all the doorsliftgate/boot lid unlock
automatically.
(Automatic transaxle vehicles only)
All the doors and the liftgate/boot lid
lock automatically when the vehicle
speed is about 20 km/h (12 mph) or
6 more.
When the shift lever is shifted to park
(P) while the ignition is switched ON,
all the doors liftgate/boot lid unlock
automatically.
*1 Other settings for the auto door lock function are
available at an expert repairer, we recommend an
Authorised Mazda Repairer. For details consult
an expert repairer, we recommend an Authorised
Mazda Repairer. Refer to Personalisation Features
on page 9-13 .
3–18
*1
Function
Settings can be changed using the
following procedure.
1. Safely park the vehicle. All doors must
remain closed.
2. Switch the ignition ON.
3. Press and hold the lock side of the
driver's door-lock switch within 20
seconds of switching the ignition ON,
and make sure a beep sound is heard
about eight seconds afterwards.
4. Refer to the auto lock/unlock function
setting table, determine the function
number for the desired setting. Press
the unlock side of the driver's door-lock
switch the same number of times as the
selected function number (Ex. If you
select function 2, press the unlock side
of the switch only 2 times).
5. Three seconds after the function setting
has been changed, a beep sound will
beep in the amount of the selected
function number. (Ex. Function number
3 = 3 beep sounds)
(Manual transaxle vehicles)
Current Function Number
Press unlock side of
lock switch once
Function Number 1
Press 2 times
Function Number 2
Press 3 times
Function Number 3
Press 4 times
Cancel setting
Press lock side of
lock switch
Cancel setting
Wait for 3 second
Function set (The
number of beeps
heard is the same as
the selected function
number)