Mazda 2 2015 Owner's Manual page 403

Interior Features
®
Bluetooth
Device selection
If several devices have been paired, the
®
Bluetooth unit links the device last
paired. If you would like to link a different
paired device, it is necessary to change the
link. The order of device priority after the
link has been changed is maintained even
when the ignition is switched off.
1. Using the audio control dial, select the
link change mode " LINK CHANGE "
in the " BT SETUP " mode. (Refer to
®
"Bluetooth audio device set-up" for
details.)
2. Press the audio control dial to
determine the mode.
3. The name of the currently linked
®
Bluetooth audio device is displayed.
®
If no Bluetooth
currently linked, the name of the fi rst
device among the paired devices is
displayed.
4. Turn the audio control dial to select the
name of the device you would like to
link.
5–102
audio device is
Device name 1
Device name 2
Device name 3
Device name 4
Device name 5
Device name 6
Device name 7
5. Press the audio control dial to select the
device you would like to link.
The " " symbol disappears, and
" PAIRING " fl ashes in the audio
display.
NOTE
When " GO BACK " is selected and the
audio control dial is pressed, the display
returns to " LINK CHANGE ".
6. If the link to the desired device is
successful, the " " symbol is displayed
again, together with " LINK
CHANGED". " LINK CHANGED " is
displayed for three seconds, then it
returns to the normal display.
NOTE
Some Bluetooth
a certain amount of time before the
" " symbol is displayed.
If a hands-free type mobile phone has
been the most recently paired device,
®
the Bluetooth
If you would like to use a Bluetooth
audio type device which has been
previously paired to the Bluetooth
unit, the link must be changed to this
device.
If an error occurs while trying to link
a device, " Err " fl ashes in the display
for three seconds, and the display
returns to " LINK CHANGE ". If this
occurs, check the pairing status of
®
the Bluetooth
location of the device in the vehicle
(not in the boot or a metal-type box),
and then try the link operation again.
Device selection can also be done
using voice recognition.
®
audio devices need
unit links this device.
audio device and the
®
®