Mounting The Device To A Panel - Siemens RUGGEDCOM RS400 Installation Manual

Hide thumbs Also See for RUGGEDCOM RS400:
Table of Contents

Advertisement

RUGGEDCOM RS400
Installation Guide
NOTE
The chassis features multiple mounting holes, allowing the rack mount adapters to be installed up
to 25 mm (1 in) from the face of the device.
1
Figure 3: Rack Mount Adaptors
1. Rear
2. Front
2.
If required, install adapters on the opposite side of the device to protect from vibrations.
3.
Insert the device into the rack.
NOTE
Since heat within the device is channelled to the enclosure, it is recommended that 1 rack-unit
of space, or 44 mm (1.75 in), be kept empty above the device. This allows a small amount of
convectional airflow.
Forced airflow is not required. However, any increase in airflow will result in a reduction of ambient
temperature and improve the long-term reliability of all equipment mounted in the rack space.
4.
Secure the adapters to the rack using the supplied hardware.
Section 2.1.3

Mounting the Device to a Panel

For panel installations, the RS400 can be equipped with panel/DIN rail adapters pre-installed on each side of the
chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1.
Place the device against the panel and align the adapters with the mounting holes.
Mounting the Device to a Panel
3. Rack Mount Adaptor
Chapter 2
Installing the Device
1
7

Advertisement

Table of Contents
loading

Table of Contents