Threaded Shaft - ParaBody 426103 Manual

3-1/2" PULLEY
3/8 X 2" BOLT
3/8" WASHER
BASE
3/8" WASHER
3/8" LOCK NUT
FIGURE 7
STEP 7
• Remove one 3-1/2" PULLEY, one 3/8 X 2" BOLT, two 3/8" WASHERS and one 3/8" LOCK NUT from the BASE as shown in FIGURE 7.
FIGURE 8
BASE
8 HEX NUT
7
3
9
3-1/2" PULLEY
3/8" LOCK NUT
3
8 HEX NUT
STEP 8
• Assemble two 3/8" HEX NUTS (8), two SWIVEL SNAP (3), one previously removed 3-1/2" PULLEY, one previously removed 3/8"
LOCK NUT, and one 3/8" LOCK NUT (7) to the 3/8" THREADED SHAFT (9) as shown in FIGURE 8.
38