Panasonic KX-TVS50 Installation Manual page 251

To program the following 10 Parameters on the following page, use the Special Commands and
Dial Codes listed below. Up to 12 digits can be set for each parameter.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Extension dialing
A: Answer
1-9, 0,
Parameter
Operator
Transfer
Sequence
Extension
Transfer
Sequence
Alternate
Extension
Transfer
Sequence
Reconnect
Sequence on
Busy
Reconnect
Sequence on
No Answer
Reconnect
Sequence on
Refuse Call
Light-On
Sequence for
Message
Waiting Lamp
Light-Off
Sequence for
Message
Waiting Lamp
SYSTEM ADMINISTRATOR'S GUIDE
, #: Dial Codes
Value Range
(Default)
This sequence is performed by the VPS when transferring
(FX) calls to the operator's extension.
This sequence is performed by the VPS when transferring
(FX) calls to any extension except the operator's.
This sequence is performed by the VPS when transferring
calls to extensions in the Alternate Extension Group.
(FX)
If an extension is busy, this sequence allows the VPS to
(F) reconnect to the caller.
If the extension does not answer, this sequence allows the
(F) VPS to reconnect with the caller.
This sequence is performed by the VPS to retrieve a call
(F) placed on hold after the extension (in the Call Screening
mode) has refused to accept it.
The dialing sequence that the VPS must perform to enable
the Message Waiting Lamp at an extension.
(None)
This is the dialing sequence that the VPS must perform to
disable the Message Waiting Lamp at an extension.
(None)
B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
Table 68
Description/Function
251