GE JHP61GJ Use And Care Manual page 29

Table of Contents

Advertisement

p
Adjusting Oven Thermostat
'
When cooking a food for the first
time in your new oven, use time
given on recipe as a guide. Oven
thermostats,
over a period of years,
may "drift" from the factory setting
and differences in timing between
an old and a new oven of 5 to 10
minutes are not unusual. Your new
oven has been set correctly at the
factory and is more apt to be accu-
rate than the oven which it replaced.
However, if you find that your
foods consistently brown too little
or too much, you may make a
simple adjustment
in the thermostat
(Oven Temp) knob.
PULL KNOB OFF OF SHAFT,
,sLOOK
AT BACK OF KNOB AND
<,, NOTE CURRENT
SETTING,
BEFORE MAKING ANY
ADJUSTMENT.
Pull off knob. Move pointer one
notch in desired direction. RAISE
to increase, LOWER to decrease.
Each notch changes temperature
10degrees.
Return knob to the range by
matching the flat area of the knob
to the shaft.
Recheck oven performance before
making an additional adjustment.
oven Vent Duct
Oven is vented through a duct
located under the right rear
Calrod@ unit. To clean duct: re-
move Calrod@ unit and drip pan/
ring. Lift out vent duct. In replac-
ing, make sure the duct opening is
under the opening in drip pan.
Correct positioning is important
to
allow moisture and vapors to be
released from oven. Never cover
the hole.
Lamp Replacement
CAUTION: Before
replacing
your
oven lamp bulb, disconnect
the
electric power for your Cooking
Center at the main fuse or circuit
breaker panel.
Be sure to let the
lamp cover and bulb cool com-
pletely before removing or
replacing them.
~~
-'0
To remove:
. Take out 3 slotted screws as
shown in lamp diagram.
Detach lamp cover and remove
bulb.
To
replace:
Put in a new 40-watt appliance
bulb.
. Install lamp cover. Replace 3
screws and tighten them, making
sure cover fits flush with oven wall.
. Reconnect electric power to the
Cooking Center.
Removable
Oven Door
I
w
\\
TO REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
TO REPLACE,
grasp door at sides.
Line up door with hinges and push
door firmly into place.
.
29

Advertisement

Table of Contents
loading

Table of Contents