System - Panasonic AJ-SD930BE Operating Instructions Manual

CONTENTS
Connector signals
PARALLEL REMOTE (25P)
Pin No.
1 PLAY COMMAND
2 STOP COMMAND
3 FF COMMAND
4 REW COMMAND
5 REC COMMAND
6 EJECT COMMAND
7 STAND BY COMMAND
8 PREROLL COMMAND
9 IN SET COMMAND
====
10
====
11
12
610 V, MAX 300 mA
13 PLAY STATUS
14 STOP STATUS
15 FF STATUS
16 REW STATUS
17 REC STATUS
18 EJECT STATUS
19 STAND BY ON STATUS
20 PREROLL STATUS
21 SERVO LOCK STATUS
22 OPERATION ENABLE STATUS
====
23
====
24
25 GND
<Notes>
O COMMAND pins: TTL level, active low, 6100ms
edge electrical signal.
O STATUS pins: open collector, sink current 6 mA
78 (E)
Signal
RS-232C
D-SUB 25-pin (crossover cable supported)
Pin No. Signal
1 FG Protective ground
(Frame ground)
2 RXD Received data
(Data is sent to PC.)
3 TXD Transmitted data
(Data is received from PC.)
4 CTS Clear to send
(Shorted with pin 5.)
5 RTS Request to send
(Shorted with pin 4.)
6 DTR Data terminal ready
(No processing)
7 SG Signal ground
(Signal ground)
20 DSR Data set ready (+ voltage output after
communication enable status)
ENCODER (15P)
Pin No.
====
1
2 BLACK LEVEL
3 C LEVEL
4 GND
5 +12V
6 SYSTEM H 0
7 SYS. SC COARSE (2)
8 –12V
9 CHROMA PHASE
10 VIDEO LEVEL
11 RET GND
====
12
====
13
14 SYS. SC FINE
15 SYS. SC COARSE (1)
Description
Signal