Rear Panel - Panasonic AJ-SD930BE Operating Instructions Manual

CONTENTS
Parts and their functions

Rear panel

AES/EBU ANALOG
CH1/2
VIDEO
IN
IN
AC IN
Y
CH3/4
IN
P B
CH1/2
REF VIDEO
OUT
IN
P R
CH3/4
OUT OPTION
Y 1 VIDEO
OUT
2
P B
(WFM)
3
P R
(SUPER)
SIGNAL
GND
SERVICE ONLY
= < > ? @ A
< Fan
This fan is used to cool down the VTR.
If, for any reason, the fan stops, "E-10" will appear
on the counter display.
= SIGNAL GND terminal
This is connected to the signal ground terminal on
the component connected to this VTR in order to
minimize noise. It is not a safety ground.
> ANALOG COMPONENT VIDEO OUT connectors
The analogue component video signals are output
through these connectors.
? ANALOG COMPOSITE VIDEO OUT connectors
The analogue composite video signals are output
through these connectors.
The waveform monitor (WFM) signal can be output
from the VIDEO OUT 2 connector.
It can be selected using setup menu No. 00 (WFM
SEL).
Video signals containing superimposed information
can be output through the VIDEO OUT 3 connector.
Whether the superimposing is to be set ON or OFF
is selected using the SUPER switch W on the front
panel.
@ RS-232C connector
A personal computer or other component can be
connected to this connector to operate the VTR.
REMOTE ANALOG
SDI
IN OUT
REMOTE IN/OUT PUSH PUSH PUSH TC
CH1 AUDIO CH2
ON IN
IN
75Ω
1
OFF
REMOTE OUT
ACTIVE
PUSH PUSH TC
CH3 CH4 THROUGH
OUT
2
ENCODER REMOTE
ON
75Ω
3
OFF MON (SUPER)
CH1 AUDIO CH2
RS-232C OUT L
OPTION
SDTI
IN OUT
PARALLEL
CH3 CH4 MON
1
R
2
B C D
A PARALLEL REMOTE connector
This connector is used when the VTR is to be
operated by an external component.
B ANALOG AUDIO OUT connectors
The analogue audio signals are output through
these connectors.
C MONITOR OUT connectors
During playback, the
(CH1/CH2/CH3/CH4) or playback signals from the
CUE track are output through these connectors.
<Note>
Noise may appear on the CUE signal at the instant
recording is started.
D SDTI input and output connectors (optional)
When the SDTI board (AJ-YAC930G, optional
accessory) is installed in this VTR, digital data can
be input and output using the SDTI (Serial Data
Transport Interface) format.
IEEE1394 digital input/output connector
(optional)
Use of an digital video interface board (AJ-
YAD955G, optional accessory) enables input/output
interfacing of the digital signals with the IEEE1394
standard.
PCM audio signals
15 (E)