Table of Contents
Advertisement
NOTES ON OPERATIONS
TO PLAYBACK
A PRE-RECORDED
ТАРЕ
e When the tape reaches its end during playback, or fast
forward, the tape wil! rewind automatically and the
CASSETTE-IN indicator will flash until another operation
button is pressed.
• It is not necessary to select the tape speed for playback.
_
Playback speed is automatically selected by VCR,
irrespective of the switch position. (Autornatically the
selected speed will appear on display.)
e During playback it is not necessary to select VCR/TV
,
SELECTOR. It will change to VCR position automatically.
* During search playback, horizontal noise bars will appear
on the TV screen.
• Any special effects playback will mute the audio.
• if the still picture contains noise, place the unit into the
slow-motion mode and readjust the SLOW TRACKING
CONTROL
until the picture clears up. Reselect the stiil
mode by pressing the PAUSE/STILL Button. A clear still
picture should result.
`
• After the VCR is in the pause or slow mode for 5 minutes
it will stop automatically for tape and video head
protection.
e Special effects playback can be activated during playback
of the tapes recorded in SP or SLP speed. Tapes
recorded in LP mode can also be viewed in special effects
playback, but the picture may be completely snowy.
TV RECORDING
PREPARATION
e With cable connections VCR and TV channel selections
may differ from those for antenna connections. Refer to
the separate Basic Guide For VCR Connections (or
according to cable service).
e If the reception of all VHF channels is unsatisfactory you
may need to tune your TV set.
• Some TV sets have electronic tuners which automatically
fine tune each channel. !f your TV set has this type of
tuner, it probably does not provide any manual
adjustment.
TO RECORD
A TV PROGRAM
(RECORDING)
e When recording ends, the tape is automatically rewound
and ejected, and the VCR will turn itself off.
• It is possible to change the Tape-Speed Selector while
you are actually recording but there will be a momentary
distortion, at the point this speed change occurs.
* After the VCR is in pause for 5 minutes it will stop
automatically tor tape and video head protection.
e The PAUSE/STILL Button does not operate in O.T.R. or
TIMER recording mode.
`
TAPE
SPEED
SELECTION
The type of tape (NV-T60, NV-T120, NV-T160) determines
the maximum length of recording time. The TAPE-SPEED
SELECTOR
sets 3 recording speeds: SP, LP and SLP.
They dete: mine how fas! the tape moves and consequently
the amount of recording "те available. (Refer to chart at
the top of page 39.) An SP recording gives the best picture
in normal playback.
SP and SLP recordings give the best
пачы
"^.
An Lr гесогапд nay be completely snowy.
special effects
ONE TOUCH
RECORDING
• If cassette erasure prevention tab is missing. the cassette
will be ejected automatically, when you press the OTR
Button or STAND BY Button.
e |f the preset time for a Timer Recording comes up during
a One Touch Recording. the One Touch Recording will
take priority.
* To check a Preset O.T.R. program, you may press the
STAND BY or O.T.R. Button on the VCR. The preset
program will be displayed for a few seconds. You may
re-set the program at this time.
• If a One Touch Recording occurs while the Timer is set .
(TIMER Indicator ON), pressing the TIMER Button OFF
will stop both the Timer and the One Touch Recording.
ә Al! tunctions except for counter reset, counter memory
and speed select including Remote Control will become
inoperable during
a One Touch Recording.
TIMER
RECORDING
• To stop a timer recording, press the TIMER Button once.
* Timer Recording will not be performed or continued if a
power interruption of more than about 2 minutes occurs
before or during Timer Recording, even if power resumes
thereafter. (If this occurs and power resumes thereafter.
the clock indication "Su 12:00 AM" will flash.)
‚ • |f the preset time of 2 programs overlap each other. the
-37-
preset time of the lower numbered program will have
priority.
SIMULCAST
(STEREO) RECORDING
AND
PLAYBACK
* Timer Recording and One Touch Recording can be used
with simuicast recording.
* While in Audio 2 CH mode the video from the VCR tuner
is recorded.
Hi-Fi AUDIO
HD SOUND
SYSTEM
• A difference in audio level may be detected between Hi-Fi
and NORMAL audio playback.
* While adjusting TRACKING CONTROL, Hi-Fi AUDIO
sound may revert to NORMAL AUDIO sound. This is
normal.
AUDIO
Multi-Plex
BROADCAST
SYSTEM
e When stereo or second audio sound 1$ recorded on this
VCR and played back on a conventional VHS УСН. the
playback sound will be monaural from the NORMAL sound
track.
.
e Опу Hi-Fi Stereo tapes will play back in stereo mode.
Tapes with standard stereo sound will play back in
monaural sound.
RE-RECORDING
• Disregard CHANNEL positions wr 37 гэ-гесот та 122 = 10
tap^.
:
e For best results, use a 75 nhin type (Coaxial) Anteanc
Cable with male phono pl: ;5 for ine Video. and ordinary
Audio Cable tor the Audio to connect the VCRs.
e For technical reasons, the quality of the дићое 3 tape v ':
uot be as gon! ат the origin...
Advertisement
Table of Contents
