Selecting The Editing Mode - Panasonic AJ-SD930BE Operating Instructions Manual

CONTENTS
Automatic editing

Selecting the editing mode

1
Select the editing mode.
For assemble editing, press the ASSEM button.
For insert editing, press the INSERT button.
ASSEM:
This sets the unit to assemble (frame-to-frame
continuity) editing mode.
INSERT:
This sets the unit to insert editing mode.
2
Select the channels to be edited.
With assemble editing, the ASSEM lamp lights.
With insert editing,
corresponding to the channels to be edited so that
their lamps light.
3
Select the VTR to be operated.
(Settings for editing using two VTRs)
Press the PLAYER or RECORDER button to select
the VTR which is to be operated.
PLAYER:
Press this button if the player VTR is to be
operated to register the edit points.
RECORDER:
Press this button if the recorder VTR (this unit)
is to be operated to register the edit points.
DVCPRO 50
ON POWER
DVCPRO
DV
OFF
METER COUNTER
FULL/FINE
RESET
L
MONITOR SELECT
R
A IN
MONITOR A VOL INPUT SELECT PREVIEW/PREVIEW AUTO EDIT PREROLL
HEADPHONES MIX SELECT
VIDEO AUDIO
CH1 CH2 CH3 CH4 TC
PRESET MENU
UNITY
REC LEVEL
PB LEVEL VAR
22 (E)
(deck-to-deck)
press the buttons
1/2 3
JOG SHTL SLOW
STAND BY PLAYER RECORDER
ASSEM VIDEO CUE TC
CH1 CH2 CH3 CH4
EDIT PLAY REC
INSERT
A OUT
TRIM
REW STOP FF
SET
IN OUT
SUPER REC INH INT TCG MODE CONTROL
SET DIAG REGEN
ON ON TAPE REMOTE
PRESET
OFF OFF EE LOCAL
EXIT
SD955B
Registering the edit points
1
Locate the edit IN point by performing the jog or
shuttle operation.
Set the tape to the still picture mode at the desired
position.
For a detailed description of the jog and shuttle
operations, refer to page 19.
2
Press the SET button while holding down the IN
button.
The edit IN point is now registered.
The edit IN point value appears on the display
panel.
3
Locate the edit OUT point by performing the jog or
shuttle operation.
Set the tape to the still picture mode at the desired
position.
4
Press the SET button while holding down the OUT
button.
The edit OUT point is now registered.
The edit OUT point value appears on the display
panel.
Match frame processing function
When two VTRs are used to perform the editing
operations, there will be a total of 4 edit points: the
IN and OUT points for the player and those for the
recorder. However, the last point is automatically
calculated so only three of the edit points need to be
registered.
ON POWER
DVCPRO
DV
OFF
METER
FULL/FINE
L
MONITOR SELECT
R
MONITOR A VOL INPUT SELECT PREVIEW/PREVIEW AUTO EDIT PREROLL
HEADPHONES MIX SELECT
VIDEO AUDIO
CH1 CH2 CH3 CH4
UNITY
REC LEVEL
PB LEVEL VAR
2/4 1/3
DVCPRO 50
JOG SHTL SLOW
STAND BY PLAYER RECORDER
COUNTER ASSEM VIDEO CUE TC
RESET CH1 CH2 CH3 CH4
EDIT PLAY REC
INSERT
A IN A OUT
TRIM
REW STOP FF
SET
IN OUT
SUPER REC INH INT TCG MODE CONTROL
TC
PRESET MENU SET DIAG REGEN
ON ON TAPE REMOTE
PRESET
OFF OFF EE LOCAL
EXIT