System - Panasonic AJ-SD930BE Operating Instructions Manual

CONTENTS
Setup menus
This VTR can hold five user files, each of which has
its own specific menu settings, and one of these files
can be selected for use.
Changing the file
1
Press the MENU button.
2
When the FF button is pressed while holding down
the DIAG button, the next user file is selected;
conversely, when the REW button is pressed while
holding down the DIAG button, the previous user
file is selected.

SYSTEM

FF REW
User files
USER 1
Each user file contains the
following items.
FF REW
O BASIC
USER 2
O OPERATION
O INTERFACE
FF REW
REW FF
O EDIT
USER 3
O TAPE PROTECT
O TIME CODE
FF REW
O VIDEO
USER 4
O AUDIO
O V BLANK
FF REW
O MENU
USER 5
3
To enter the selection made in step
file which is to be used, press the SET button.
The user file is changed and stored in the memory.
<Note>
Since the SYSTEM menu items are not included in
user files 1 through 5, first select the user file and
switch to the SYSTEM file, and then set the SYSTEM
menu items.
30 (E)
Setting and releasing the lock mode
The lock mode can be set to protect the system file
and user file (USER2 to USER5) settings. Once the
lock mode is set, no further changes can be made to
the settings.
Setting and releasing the lock mode can be set for the
system file by using setup menu No. 30 (MENU
LOCK) and for the user files by using setup menu No.
A03 (MENU LOCK).
1
Press the MENU button.
2
Press the REW button or FF button while holding
down the DIAG button to select the file for which
the lock mode is to be set or released.
3
Turn the search dial to move the cursor (2) on the
menu screen to No. 30 (MENU LOCK) for the
system file or to No. A03 (MENU LOCK) for a user
file.
4
Turn the search dial while holding down the search
button to select whether the lock mode is to be set
or released.
To set the lock mode:
Set 0001 (ON) as the setting.
To release the lock mode:
Set 0000 (OFF) as the setting.
When the lock mode has been set, "LOCKED"
flashes on the menu screen. The counter display
2
for the user
stops flashing and remains lit.
5
Press the SET button.
The setting is stored in the memory.
<Notes>
O The lock mode cannot be set for the USER1 file.
O Once set to the lock mode, a file cannot be reset to
the factory settings even by pressing the RESET
button.
S E T U P - M E N U L O C K E D
< U S E R 2 > N O . 0 0 0 - 0 0 0 5
20 0 0 P - R O L L T I M E
0 0 1 L O C A L E N A S T & E J
0 0 2 T A P E T I M E R ± 1 2 h
0 0 3 R E M A I N S E L
0 0 4 S E T U P N U M B E R
0 0 5 M E T E R S E L E C T
0 0 6 S Y N C H R O N I Z E
0 0 7 S U P E R
0 0 8 D I S P L A Y S E L T & S T A
5 s
O F F
O F F
C U E
O N
O N