Turning Off The Power - Panasonic PT-P1SDE Operating Instructions Manual

Turning off the power

# $
POWER button
,
%
Mains lead
Press the POWER button.
#
BThe "POWER OFF" confirmation screen
will be displayed.
Press the POWER button again.
$
BThe lamp unit will switch off and the picture will stop being projected.
(The POWER button on the projector will illuminate orange while the
cooling fan is still operating.)
NOTE:
BPress any button other than the POWER button to cancel the "POWER
OFF" screen.
BThe "POWER OFF" screen will disappear in five seconds.
% Disconnect the mains lead after the POWER
button on the projector illuminates red.
NOTE:
B You can also turn off the power by holding down the POWER button for
at least 0.5 seconds.
28-E
NGLISH
POWER INPUT MENU
ENTER
AUTO
SETUP
STD
SHUTTER
RETURN
VOLUME
ENTER
ROTATE
P O W E R O F F
[ P O W E R ] O K
Direct power off function
You can disconnect the mains lead during projection or immediately after
use and move the projector. The cooling fan will operate by the internal
power supply to cool down the lamp.
B When this function is used, it may take more time for the lamp to turn back
on again compared to when the lamp cools down with the mains lead
connected.
B Do not put the projector in the softcase while the POWER button on the
projector is illuminated.
NOTE:
B Do not disconnect the mains lead while the files in the SD memory card
are being played back.
CAUTION
If not using the projector for an extended period of time, disconnect the
mains plug from the mains socket.
B If dust builds up on the mains plug, the resulting humidity may damage the
insulation, which could result in fire.
B This projector continues to draw approximately 3 W of power even when
the power is turned off.
POWER button on the projector
POWER button status
The projector is in standby mode and image projection
Red Illuminated
is possible by pressing the POWER button.
The projector is preparing for projection after the
power has been turned on while the POWER button
Flashing
on the projector is illuminated red. (After a short
Green
period, a picture will be projected.)
Illuminated A picture is being projected.
The lamp is cooling down after the power has been
Illuminated turned off or while direct power off function is
operating.
Orange
The projector is preparing for projection after the
power has been turned on while the POWER button
Flashing
on the projector is illuminated orange. (After a short
period, a picture will be projected.)
Projector status
E -29
NGLISH