Starting To Use; Turning On The Power; Turning Off The Power - Panasonic PT-L780U Operating Instructions Manual

Starting to use

Turning on the power

Please ensure that all preparations have been completed before turning on
the power. (Refer to pages 22 – 27.)
# Remove the lens cover.
$ Connect the accessory power cord.
% Press the MAIN POWER switch to
the "l" side to turn on the power.
The power indicator on the projector
will illuminate red.
& Press the POWER button.
The power indicator on the projector
will flash green. After a short period,
the indicator will illuminate green, and
a picture will be projected.
' Press the input select (RGB, VIDEO)
button to select the input signal.
The input signal selected will change
as shown at below each time an input
select button is pressed.
VIDEO
VIDEO
S-VIDEO
VIDEO
( While pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector.
To make fine adjustments to the angle of
tilt of the projector, turn the front
adjustable legs. (The front adjustable legs
will be locked if they are fully extended
and then turned anticlockwise. Turn them
back clockwise to release the lock.)
) Press the AUTO SETUP button to
initiate automatic positioning.
The automatic positioning is only for vertical
keystone distortion. To correct the
horizontal keystone distortion or when
keystone distortion has not been corrected
to the optimum level, carry out the keystone
correction as described on page 40.
28
All manuals and user guides at all-guides.com
$
RGB INPUT
POWER AUTO SETUP
STANDBY(R)
ON(G)
– +
FOCUS
– + MENU
ZOOM
RGB INPUT
POWER AUTO SETUP
STANDBY(R)
ON(G)
– +
FOCUS
– + MENU
ZOOM
SD CARD
RGB
RGB
NETWORK
DVI
RGB3
RGB2
RGB1
RGB INPUT
POWER AUTO SETUP
STANDBY(R)
ON(G)
– +
FOCUS
MENU
– +
ZOOM
%
TEMP
LAMP
INPUT
VIDEO RGB SHUTTER
AUTO
POWER SETUP
RGB LASER
VIDEO MENU
PAGE
ENTER
TEMP
LAMP
INPUT
AUTO
POWER SETUP
VIDEO RGB SHUTTER
RGB LASER
VIDEO MENU
PAGE
ENTER
LAMP TEMP
INPUT
VIDEO RGB SHUTTER
AUTO
POWER SETUP
RGB LASER
VIDEO MENU
PAGE
ENTER
*Press the FOCUS +/- or ZO
buttons to adjust the proje
image focus and size.
The projected image focus c
adjusted by turning the focus
make fine adjustments to the
image focus, use the FOCUS
Turning off the powe
# Press the POWER button.
OFF" is displayed on the
$ Select "OK" using the I I a
buttons and press the EN
The lamp unit will switch off
power indicator on the proje
% Wait until the power indic
the cooling fan stops).
Do not in any way cut powe
operating. Be careful not to
projector, unplug the power
switches such as tabletop p
& Press the MAIN POWER s
NOTE:
B After the power is turned off
down. If you turn the power
down, the lamp unit may no
automatically after a short p
the projector will flash orang
B When the projector is in sta
projector is illuminated red),
of power, even when the co
B If the MAIN POWER switch
being used, the lamp unit m
turned back on. In such cas
automatically after a short p
the projector will flash green
B A tinkling sound may be hea
this is not a sign of a malfun
B You can also turn off the po
B When the WEB STANDBY
the power indicator on the p
draw a maximum 43 W of p
B Do not turn off the power wh
card is in use " is displayed o