Table of Contents
Advertisement
Location and function of each part
Projector
<Top, right and front>
,
+
*
)
( '
# Projector control panel (page 16)
$ SD memory card slot
% Back adjustable leg (page 27)
& Illumination sensor and LAMP/TEMP indicators (page 16)
' Remote control signal receptor (page 24)
( Lens cover (page 62)
Use the projector with the lens cover attached.
) Front leg adjuster button (page 27)
This button is used to unlock the front adjustable leg. Press to adjust the
angle of tilt of the projector.
* Air inlet port
Do not cover this port.
+ Focus ring (page 27)
, Zoom ring (page 27)
14-E
NGLISH
#
$
%
&
Projector
<Back and bottom>
#
$
(
# Connector panel (page 19)
$ Speaker
% Air outlet port
Do not cover this port.
& Lamp unit cover (page 58)
' Front adjustable leg (page 27)
( Air inlet port, Air filter (page 56)
Do not cover this port.
NOTE:
B During projection of an image, the cooling fan will operate, emitting a
small noise as it operates. This noise may change depending on the
ambient temperature. Turning the lamp on or off will cause this noise to
increase a little.
WARNING
Do not place your hands or other objects close to the air outlet port.
B Heated air comes out of the air outlet port. Do not place your hands or
face, or objects which cannot withstand heat close to this port [allow at
least 10cm (4") of space], otherwise burns or damage could result.
%
&
'
E
-15
NGLISH
Hide quick links:
Advertisement
Table of Contents
