Rinnai RHFE-308FTR How To Use Manual page 2

RINNAI GUARANTEE,OF QUALRY,
-'
As the purchaser of this high quality model RHFE-308FTR Rinnai product you are provided
with the following guarantee:
Free Labour
Free Parts
Heat Exchanger 1 Year
10 Years pro rata *
Fan 1 Year
2 Years
All other parts 1 Year 1 Year
*Full Heat Exchanger replacement (parts only) in the first year, thereafter reducing
at 10%
per year.
The benefits conferred by this guarantee are in addition to all other rights and remedies in respect of
the product which you have under the Trade Practices Act and other State and Territory
Laws. This
guarantee does not cover cleaning and normal wear and tear, calls of this nature may be chargeable.
Please check the fault finding charts on pages 18, 19, and 20, before asking for a service call. You
may be able to overcome the problem without a service call, or the heater may be operating normally.
Service calls to a heater which is operating normally may be chargeable, even when the heater is
under guarantee.
The Installer is responsible for your heater's correct installation. There is no requirement to post the
following information back to Rinnai. However we advise that you keep it .in a safe place as your record.
Date of purchase:
Retailers name:
Address:
Telephone:
Date of installation:
Installers name:
Address:
Telephone:
Licence number:
This appliance shall be installed in accordance with:
Manufacturer's Installation Instructions
Local Gas Fitting Regulations
Municipal Building Codes
A.G.A. Installation Code for Gas Burning Equipment
Any other relevant Statutory regulation
This appliance must only be installed, serviced and removed by an Authorised Person
This appliance must be installed correctly by an Authorised Person. The installation of gas, and
electricity must conform to local regulations.
The installation must also conform with the instructions supplied by Rinnai.. Your Energysaver
has been approved by the Australian GaslAssociation.
A.G.A. Approval Number: 5209
Please keep this instruction booklet in a safe place for future reference.
All dimensions referred to in these instructions are in millimetres, unless otherwise specified.
-l-